Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 5.99.56 (_pegi_) #0: Sun Oct 23 22:50:46 PDT 2011 mrg@xotica.eterna23.net:/var/obj/ofppc/usr/src3/sys/arch/ofppc/compile/_pegi_ Model: Pegasos2 total memory = 512 MB avail memory = 481 MB timecounter: Timecounters tick every 10.000 msec bootpath: /pci@80000000/ide@C,1/disk@0,0/netbsd mainbus0 (root) rtas0 at mainbus0: version 1, entry @pa 0x643000 cpu0 at mainbus0: 7457 (Revision 1.1), ID 0 (primary) cpu0: HID0 0x84d0c1bc, powersave: 1 cpu0: 1000.00 MHz, 512KB L2 cache parity enabled cpu0: L1 I-cache 32 KB 32B/line, D-cache 32 KB 32B/line cpu0: L2 cache 256 KB 64B/line cpu0: L3 cache 1 MB 128B/line gt0 at mainbus0Switching to COM console at speed 115200 : MV6436x Discovery II gt0: id 0, MPX bus, snoop=clean&flush wdog=0x60ffffff,0 gt0: pipeline aack-delay conf-sb-dis gtidmac at gt0 unit 0 not configured gtmpsc at gt0 unit 0 not configured gtmpsc at gt0 unit 1 not configured gtpci0 at gt0 unit 0: Marvell PCI Interface pci0 at gtpci0 pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok pchb0 at pci0 dev 0 function 0 pchb0: Marvell MV6436x System Controller (rev. 0x03) genfb0 at pci0 dev 8 function 0: ATI Technologies Radeon 9200PRO 5960 genfb0: framebuffer at 0xc0000000, size 800x600, depth 8, stride 800 wsdisplay1 at genfb0 kbdmux 1 wsmux1: connecting to wsdisplay1 drm at genfb0 not configured genfb1 at pci0 dev 8 function 1: ATI Technologies Radeon 9200 Pro Secondary bus_space_map(0x5b823c[c0000000:e0000000], 0xc0000000, 0x75300) failed: 35 genfb1: unable to map the framebuffer gtpci1 at gt0 unit 1: Marvell PCI Interface pci1 at gtpci1 pci1: i/o space, memory space enabled, rd/line, wr/inv ok pchb1 at pci1 dev 0 function 0 pchb1: Marvell MV6436x System Controller (rev. 0x03) fwohci0 at pci1 dev 1 function 0: VIA Technologies VT6306 IEEE 1394 Host Controller (rev. 0x46) fwohci0: interrupting at irq 9 fwohci0: OHCI version 1.0 (ROM=1) fwohci0: No. of Isochronous channels is 8. fwohci0: EUI64 00:11:06:00:00:00:4b:2f fwohci0: Phy 1394a available S400, 3 ports. fwohci0: Link S400, max_rec 2048 bytes. ieee1394if0 at fwohci0: IEEE1394 bus fwip0 at ieee1394if0: IP over IEEE1394 fwohci0: Initiate bus reset pcib0 at pci1 dev 12 function 0: VIA Technologies VT8231 PCI-ISA Bridge (rev. 0x10) pcib0: PIRQ[0-3] not used viaide0 at pci1 dev 12 function 1 viaide0: VIA Technologies VT8231 ATA100 controller viaide0: bus-master DMA support present viaide0: primary channel configured to native-PCI mode viaide0: primary channel interrupting at irq 14 atabus0 at viaide0 channel 0 viaide0: secondary channel configured to native-PCI mode viaide0: secondary channel interrupting at irq 15 atabus1 at viaide0 channel 1 uhci0 at pci1 dev 12 function 2: VIA Technologies VT83C572 USB Controller (rev. 0x1e) uhci0: interrupting at irq 9 usb0 at uhci0: USB revision 1.0 uhci1 at pci1 dev 12 function 3: VIA Technologies VT83C572 USB Controller (rev. 0x1e) uhci1: interrupting at irq 9 usb1 at uhci1: USB revision 1.0 viaenv0 at pci1 dev 12 function 4: VIA Technologies VT8231 Hardware Monitor viaenv0: Hardware Monitor disabled timecounter: Timecounter "viaenv0" frequency 3579545 Hz quality 1000 viaenv0: 24-bit timer auvia0 at pci1 dev 12 function 5: VIA Technologies VT82C686A AC'97 Audio (rev 0x40) auvia0: interrupting at irq 9 auvia0: ac97: SigmaTel STAC9766/67 codec; headphone, 20 bit DAC, 18 bit ADC, SigmaTel 3D auvia0: ac97: ext id 0x605 audio0 at auvia0: full duplex, playback, capture, mmap, independent VIA Technologies VT82C686A MC-97 Modem Controller (miscellaneous communications, revision 0x20) at pci1 dev 12 function 6 not configured vr0 at pci1 dev 13 function 0: VIA Technologies VT6102 (Rhine II) 10/100 Ethernet (rev. 0x51) vr0: interrupting at irq 9 vr0: Ethernet address: 00:0b:2f:49:ab:4a rlphy0 at vr0 phy 16: RTL8201L 10/100 media interface, rev. 1 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto isa0 at pcib0 lpt0 at isa0 port 0x3bc-0x3bf irq 7 com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo com1: console pckbc0 at isa0 port 0x60-0x64 attimer0 at isa0 port 0x40-0x43 pcppi0 at isa0 port 0x61 fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2 attimer0: attached to pcppi0 gttwsi at gt0 unit 0 not configured mvgbec0 at gt0 unit 0 offset 0x0000-0x3fff: Marvell Gigabit Ethernet Controller mvgbe at mvgbec0 port 0 not configured mvgbe0 at mvgbec0 port 1 irq 9 mvgbe0: Ethernet address 00:0b:2f:68:f3:30 makphy0 at mvgbe0 phy 7: Marvell 88E1111 Gigabit PHY, rev. 1 makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto mvgbe at mvgbec0 port 2 not configured biomask 1a000000 netmask 1a000000 ttymask 1a000000 timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0 timecounter: Timecounter "mftb" frequency 33333333 Hz quality 100 fwohci0: BUS reset fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode ieee1394if0: 1 nodes, maxhop <= 0 cable IRM irm(0) (me) ieee1394if0: bus manager 0 fdcintr: got probe interrupt IPsec: Initialized Security Association Processing. uhub0 at usb0: VIA Technologies UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhub1 at usb1: VIA Technologies UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered fdcintr: got probe interrupt wd0 at atabus0 drive 0 wd0: wd0: drive supports 16-sector PIO transfers, LBA48 addressing wd0: 38166 MB, 77545 cyl, 16 head, 63 sec, 512 bytes/sect x 78165360 sectors wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100) wd0(viaide0:0:0): using PIO mode 4, Ultra-DMA mode 5 (Ultra/100) (using DMA) wd1 at atabus1 drive 0 wd1: wd1: drive supports 16-sector PIO transfers, LBA48 addressing wd1: 38166 MB, 77545 cyl, 16 head, 63 sec, 512 bytes/sect x 78165360 sectors wd1: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100) wd1(viaide0:1:0): using PIO mode 4, Ultra-DMA mode 5 (Ultra/100) (using DMA) fdcintr: got probe interrupt Kernelized RAIDframe activated Component on: wd0a: 77747670 Row: 0 Column: 1 Num Rows: 1 Num Columns: 2 Version: 2 Serial Number: 8973783 Mod Counter: 1266 Clean: Yes Status: 0 sectPerSU: 128 SUsPerPU: 1 SUsPerRU: 1 RAID Level: 1 blocksize: 512 numBlocks: 77747584 Autoconfig: Yes Contains root partition: Yes Last configured as: raid0 Component on: wd1a: 77747670 Row: 0 Column: 0 Num Rows: 1 Num Columns: 2 Version: 2 Serial Number: 8973783 Mod Counter: 1266 Clean: Yes Status: 0 sectPerSU: 128 SUsPerPU: 1 SUsPerRU: 1 RAID Level: 1 blocksize: 512 numBlocks: 77747584 Autoconfig: Yes Contains root partition: Yes Last configured as: raid0 Found: wd1a at 0 Found: wd0a at 1 RAID autoconfigure Configuring raid0: Starting autoconfiguration of RAID set... Looking for 0 in autoconfig Found: wd1a at 0 Looking for 1 in autoconfig Found: wd0a at 1 raid0: allocating 20 buffers of 65536 bytes. raid0: RAID Level 1 raid0: Components: /dev/wd1a /dev/wd0a raid0: Total Sectors: 77747584 (37962 MB) boot device: raid0 root on raid0a dumps on raid0b mountroot: trying ntfs... mountroot: trying nfs... mountroot: trying msdos... mountroot: trying ext2fs... mountroot: trying ffs... root file system type: ffs init: copying out path `/sbin/init' 11