[ 1.0000000] phys segment: 0x5e000 @ 0x2000 [ 1.0000000] adding 0x5e000 @ 0x2000 to freelist 0 [ 1.0000000] phys segment: 0x746000 @ 0x60000 [ 1.0000000] adding 0x8000 @ 0x60000 to freelist 0 [ 1.0000000] skipping 0x73e000 @ 0x68000 (kernel) [ 1.0000000] phys segment: 0x5aa000 @ 0x7a6000 [ 1.0000000] adding 0x5aa000 @ 0x7a6000 to freelist 0 [ 1.0000000] phys segment: 0xec00000 @ 0x1400000 [ 1.0000000] adding 0xec00000 @ 0x1400000 to freelist 0 [ 1.0000000] Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, [ 1.0000000] 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, [ 1.0000000] 2018, 2019, 2020, 2021 The NetBSD Foundation, Inc. All rights reserved. [ 1.0000000] Copyright (c) 1982, 1986, 1989, 1991, 1993 [ 1.0000000] The Regents of the University of California. All rights reserved. [ 1.0000000] NetBSD 9.99.80 (_rsdio_) #17: Thu Feb 25 21:58:22 PST 2021 [ 1.0000000] mrg@yesterday-when-i-was-mad.eterna23.net:/var/obj/sgimips-mipseb/usr/src/sys/arch/sgimips/compile/_rsdio_ [ 1.0000000] total memory = 256 MB [ 1.0000000] (6848 KB reserved for ARCS) [ 1.0000000] avail memory = 236 MB [ 1.0000000] mainbus0 (root): SGI-IP32 [SGI, 7], 1 processor [ 1.0000000] cpu0 at mainbus0: MIPS R12000 CPU (0xe23) Rev. 2.3 with unknown FPC type (0x900) Rev. 0.0 [ 1.0000000] cpu0: 64 TLB entries, 16MB max page size [ 1.0000000] cpu0: 32KB/64B 2-way set-associative L1 instruction cache [ 1.0000000] cpu0: 32KB/32B 2-way set-associative write-back L1 data cache [ 1.0000000] cpu0: 1024KB/64B 2-way set-associative write-back L2 data cache [ 1.0000000] crime0 at mainbus0 addr 0x14000000: rev 1.1 (CRIME_ID: 161) [ 1.0000000] crmfb0 at mainbus0 addr 0x16000000: SGI CRIME Graphics Display Engine [ 1.0000000] crmfb0: initial resolution 1280x1024 [ 1.0000000] crmfb0: allocated 5242880 byte fb @ 0x80cc0000 (0xa1400000) [ 1.0000000] wsdisplay0 at crmfb0 kbdmux 1 [ 1.0000000] mace0 at mainbus0 addr 0x1f000000 [ 1.0000000] lpt0 at mace0 offset 0x380000 intr 4 intrmask 0xf0000 [ 1.0000000] com0 at mace0 offset 0x390000 intr 4 intrmask 0x3f00000: ns16550a, 1-byte FIFO [ 1.0000000] com0: console [ 1.0000000] com1 at mace0 offset 0x398000 intr 4 intrmask 0xfc000000: ns16550a, 1-byte FIFO [ 1.0000000] macekbc0 at mace0 offset 0x320000 intr 5 intrmask 0x0: PS2 controller [ 1.0000000] mcclock0 at mace0 offset 0x3a0000 intrmask 0x0 [ 1.0000000] mec0 at mace0 offset 0x280000 intr 3 intrmask 0x0: MAC-110 Ethernet, rev 1 [ 1.0000000] mec0: Ethernet address 08:00:69:0e:ce:27 [ 1.0000000] nsphy0 at mec0 phy 27: DP83840 10/100 media interface, rev. 1 [ 1.0000000] nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 100baseT4, auto [ 1.0000000] mavb0 at mace0 offset 0x300000 intr 6 intrmask 0x0: can't power up conversion resources [ 1.0000000] macepci0 at mace0 offset 0x80000 intr 7 intrmask 0x0: rev 1 [ 1.0000000] PCI bus 0: Warning: Total bandwidth exceeded!? (5333333) [ 1.0000000] pci0 at macepci0 bus 0 [ 1.0000000] ahc0 at pci0 dev 1 function 0: Adaptec aic7880 Ultra SCSI adapter [ 1.0000000] ahc0: interrupting at crime interrupt 8 [ 1.0000000] ahc0: Using left over BIOS settings [ 1.0000000] ahc0: Host Adapter has no SEEPROM. Using default SCSI target parameters [ 1.0000000] ahc0: aic7880: Ultra Wide Channel A, SCSI Id=0, 16/253 SCBs [ 1.0000000] scsibus0 at ahc0: 16 targets, 8 luns per target [ 1.0000000] ahc1 at pci0 dev 2 function 0: Adaptec aic7880 Ultra SCSI adapter [ 1.0000000] ahc1: interrupting at crime interrupt 9 [ 1.0000000] ahc1: Using left over BIOS settings [ 1.0000000] ahc1: Host Adapter has no SEEPROM. Using default SCSI target parameters [ 1.0000000] ahc1: aic7880: Ultra Wide Channel A, SCSI Id=0, 16/253 SCBs [ 1.0000000] scsibus1 at ahc1: 16 targets, 8 luns per target [ 1.0000000] re0 at pci0 dev 3 function 0: RealTek 8169/8110 Gigabit Ethernet (rev. 0x10) [ 1.0000000] re0: interrupting at crime interrupt 10 [ 1.0000000] re0: RTL8169S (0x0400) [ 1.0000000] re0: Ethernet address 00:1e:2a:b7:61:5f [ 1.0000000] rgephy0 at re0 phy 7: RTL8211 1000BASE-T media interface [ 1.0000000] rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto [ 1.0000000] entropy: WARNING: extracting entropy too early [ 1.0000030] scsibus0: waiting 2 seconds for devices to settle... [ 1.0717133] scsibus1: waiting 2 seconds for devices to settle... [ 3.4039420] sd0 at scsibus0 target 2 lun 0: disk fixed [ 3.5684853] sd0: 8682 MB, 11474 cyl, 5 head, 309 sec, 512 bytes/sect x 17781520 sectors [ 3.6631193] sd0: sync (50.00ns offset 8), 16-bit (40.000MB/s) transfers, tagged queueing [ 4.0257597] cd0 at scsibus0 target 4 lun 0: cdrom removable [ 4.1285412] cd0: sync (50.00ns offset 15), 8-bit (20.000MB/s) transfers [ 21.0302349] boot device: mec0 [ 21.0727624] root device (default mec0): sd0a [ 21.2183394] dump device (default sd0b): [ 21.2183394] file system (default generic): [ 21.2183394] root on sd0a dumps on sd0b [ 21.2183394] root file system type: ffs [ 21.2183394] kern.module.path=/stand/sgimips/9.99.80/modules [ 21.6415933] init path (default /sbin/init): [ 21.6415933] init: trying /sbin/init