*** keyboard not plugged in ... ff.fe.fd.fc.fb.fa.f9.f8.f7.f6.f5. ef.df.ee.ed.ec.f4.eb.ea.e9.e8.e7.e6.....e5. V7.0-9, built on Mar 18 1999 at 13:41:11 CPU 0 booting (boot dka300.3.0.6.0 -flags 0,0) failed to open dka300.3.0.6.0 Retrying, type ^C to abort... (boot dka300.3.0.6.0 -flags 0,0) >>>^C >>>sh conf Firmware SRM Console: V7.0-9 ARC Console: 4.58 PALcode: VMS PALcode V5.56-2, OSF PALcode X1.46-2 Serial Rom: V4.6 Diag Rom: V1.6 Processor DECchip (tm) 21064-3 166Mhz 512KB Cache MEMORY 128 Meg of System Memory Bank 0 = 64 Mbytes(32 MB Per Simm) Starting at 0x0 Bank 1 = 64 Mbytes(32 MB Per Simm) Starting at 0x4000000 Bank 2 = No Memory Detected PCI Bus Bus 00 Slot 06: NCR 810 Scsi Controller pka0.7.0.6.0 SCSI Bus ID 7 dka0.0.0.6.0 IBM DDRS-34560 mka500.5.0.6.0 TLZ07 Bus 00 Slot 07: Intel SIO 82378 Bus 00 Slot 11: DECchip 21040 Network Controller ewa0.0.0.11.0 08-00-2B-XX-XX-XX Bus 00 Slot 13: Digital ZLXp Graphics Controller ISA Slot Device Name Type Enabled BaseAddr IRQ DMA 0 0 MOUSE Embedded Yes 60 12 1 KBD Embedded Yes 60 1 2 COM1 Embedded Yes 3f8 4 3 COM2 Embedded Yes 2f8 3 4 LPT1 Embedded Yes 3bc 7 5 FLOPPY Embedded Yes 3f0 6 2 1 0 SL811 Singleport Yes 300 9 >>>sh dev dka0.0.0.6.0 DKA0 IBM DDRS-34560 S97B dva0.0.0.0.1 DVA0 mka500.5.0.6.0 MKA500 TLZ07 4BE0 ewa0.0.0.11.0 EWA0 08-00-2B-XX-XX-XX pka0.7.0.6.0 PKA0 SCSI Bus ID 7 >>>sh mem 128 Meg of System Memory Bank 0 = 64 Mbytes(32 MB Per Simm) Starting at 0x0 Bank 1 = 64 Mbytes(32 MB Per Simm) Starting at 0x4000000 Bank 2 = No Memory Detected >>>boot dka0 (boot dka0.0.0.6.0 -flags 0,0) block 0 of dka0.0.0.6.0 is a valid boot block reading 81 blocks from dka0.0.0.6.0 bootstrap code read in base = 1f2000, image_start = 0, image_bytes = a200 initializing HWRPB at 2000 initializing page table at 1e4000 initializing machine state setting affinity to the primary CPU jumping to bootstrap code NetBSD/alpha 7.99.43 ustar Bootstrap, Revision 1.3 VMS PAL rev: 0x1000000010538 OSF PAL rev: 0x100000002012e Switch to OSF PAL code succeeded. Boot flags: 0,0 10840336+206368=0xa88f70 Entering netbsd at 0xfffffc0000a01220... Unrecognized boot flag '0'. Unrecognized boot flag ','. Unrecognized boot flag '0'. Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 7.99.43 (INSTALL.201612011010Z) AlphaStation 200 4/166, 166MHz, s/n 8192 byte page size, 1 processor. total memory = 128 MB (2000 KB reserved for PROM, 126 MB used by NetBSD) avail memory = 113 MB mainbus0 (root) cpu0 at mainbus0: ID 0 (primary), 21064-0 apecs0 at mainbus0: DECchip 21071 Core Logic chipset apecs0: DC21071-CA pass 2, 64-bit memory bus apecs0: DC21071-DA pass 2 pci0 at apecs0 bus 0 siop0 at pci0 dev 6 function 0: Symbios Logic 53c810 (fast scsi) siop0: interrupting at isa irq 11 scsibus0 at siop0: 8 targets, 8 luns per target sio0 at pci0 dev 7 function 0: vendor 8086 product 0484 (rev. 0x03) tlp0 at pci0 dev 11 function 0: DECchip 21040 Ethernet, pass 2.3 tlp0: interrupting at isa irq 5 tlp0: Ethernet address 08:00:2b:xx:xx:xx tlp0: 10baseT, 10baseT-FDX, 10base5, manual tga0 at pci0 dev 13 function 0: DC21030 step C, board type T8-02 tga0: 1024 x 768, 8bpp, Bt485 RAMDAC tga0: interrupting at isa irq 10 wsdisplay0 at tga0 (kbdmux ignored) isa0 at sio0 lpt0 at isa0 port 0x3bc-0x3bf irq 7 com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo com0: console com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo pckbc0 at isa0 port 0x60-0x64 fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2 mcclock0 at isa0 port 0x70-0x71: mc146818 compatible time-of-day clock scsibus0: waiting 2 seconds for devices to settle... sd0 at scsibus0 target 0 lun 0: disk fixed sd0: 4357 MB, 8387 cyl, 5 head, 212 sec, 512 bytes/sect x 8925000 sectors sd0: sync (100.00ns offset 8), 8-bit (10.000MB/s) transfers, tagged queueing fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec st0 at scsibus0 target 5 lun 0: tape removable st0: drive empty st0: sync (200.00ns offset 8), 8-bit (5.000MB/s) transfers sd0: no disk label WARNING: 1 error while detecting hardware; check system log. root on md0a dumps on md0b root file system type: ffs kern.module.path=/stand/alpha/7.99.43/modules Terminal type? [vt100]