This is a listing of vendors who provide commercial hardware with specific support for NetBSD. A wide variety of commercial hardware runs NetBSD itself; this page is for products that specifically support NetBSD. There are also pages for commercial software products for NetBSD and preinstalled NetBSD systems. According to Simtec, the "StrongARM 110 Evaluation Board" is based on Intel's 21281 SA110 StrongARM processor and 21285 support chip, along with Acer Labs' M1543c southbridge chip. It supports up to 256MB onboard SDRAM, and its integrated I/O includes dual IDE, USB host interface, and serial and parallel ports; plus, it offers three PCI and three ISA slots for further system expansion. Details ADCOMTEC specializes in providing high-performance, advanced communications and networking solutions. NetBSD driver support is provided for a range of high-performance WAN adapters for ADSL,, T1, E1, and Synchronous Serial (RS- 232/V.35/X.21/EIA530) connectivity that support a number of downloadable protocol modules including ATM, Frame Relay, X.25, HDLC, SDLC, PPP and SS7. http://www.adcomtec.com Chase Research (now a part of Perle Systems) produces terminal servers and access servers, and includes software support for dialout modem pools under NetBSD i386, and linking network modems to fixed tty devices for dial-in support. Computer Protocol Malaysia offers the CP800, a synchronous Serial Adapter Card, and drivers for NetBSD/i386 Speecys Corp. has been developing networked robots powerd by NetBSD operating system. See this link for more information. One Stop Systems, Inc. specializes in providing high-performance, advanced communications and networking solutions for CompactPCI, PCI, and PMC based applications. NetBSD driver support is provided for a range of high-performance adapters providing connectivity Synchronous Serial, T1/E1, DS3/T3, and HSSI. All of the following come with an Open Source NetBSD Driver wanADAPT-1SSI Synchronous Serial WAN Adapter (PCI) RS-232, EIA-530, RS-449, V.35, V.36 and X.21bis Cable selects proper electrical interface standard Hardware performs HDLC functions (Flags, bit-stuffing, CRCs) Transmits and receives variable length frames Can receive minimum sized frames with single flag separator Data bit rates up to 10Mbps wanADAPT-1HSSI HSSI WAN Adapter (PCI) Full T3 to support DS3 Network Service Unit Full E3 for speeds of up to 32Mbps Fractional T3 and E3 bandwidth Inverse T1 and E1 multiplexors DTE to DCE connectivity Hardware performs HDLC functions (flags, bit-stuffing, CRCs) Uses Scatter/Gather Bus Master DMA Transmits and receives variable length frames Data bit rates up to 52 Mbps wanADAPT-1T3 DS3/T3 WAN Adapter (PCI) On board DSX-3 transceiver Two 75 ohm BNC coaxial connectors Full Duplex connectivity at DS3 rate of 44.736 Mbps B3ZS line encoding/decoding C-bit parity encoding and error counting Far End Block Error (FEBE) detection and counters Fully integrates DS3 Framer and Transceiver Hardware performs HDLC functions (flags, bit-stuffing, CRCs) Uses Scatter/Gather Bus Master DMA wanPMC-1SSI Synchronous Serial WAN Adapter Supports wide range of serial interfaces including: RS-232, EIA-530, RS-449, V.35, V.36 and X.21bis Cable selects proper electrical interface standard Hardware performs HDLC functions (Flags, bit-stuffing, CRCs) Transmits and receives variable length frames Can receive minimum sized frames with single flag separator Data bit rates up to 10Mbps wanPMC-1HSSI HSSI WAN Adapter Full T3 to support DS3 Network Service Unit Full E3 for speeds of up to 32Mbps Fractional T3 and E3 bandwidth Inverse T1 and E1 multiplexors DTE to DCE connectivity Hardware performs HDLC functions (flags, bit-stuffing, CRCs) Uses Scatter/Gather Bus Master DMA Transmits and receives variable length frames Data bit rates from 1.5 Mbps to 52 Mbps wanPMC-1T3 DS3/T3 WAN Adapter On board DSX-3 transceiver Two 75 ohm BNC coaxial connectors Full Duplex connectivity at DS3 rate of 44.736 Mbps B3ZS line encoding/decoding C-bit parity encoding and error counting Far End Block Error (FEBE) detection and counters Fully integrates DS3 Framer and Transceiver Hardware performs HDLC functions (flags, bit-stuffing, CRCs) Uses Scatter/Gather Bus Master DMA Quad PMC Module SBE's wanPMC-C4T1E1 is a single wide PMC module that combines four full featured front panel accessible T1/E1/J1 ports with a 128 channel communications controller incorporating SS7, HDLC and transparent mode protocol support. wanADAPT-1HSSIc HSSI WAN Adapter Full T3 to support DS3 Network Service Unit Full E3 for speeds of up to 32Mbps Fractional T3 and E3 bandwidth Inverse T1 and E1 multiplexors DTE to DCE connectivity Hardware performs HDLC functions (flags, bit-stuffing, CRCs) Uses Scatter/Gather Bus Master DMA Transmits and receives variable length frames Data bit rates up to 52 Mbps Team ASA, Inc. designs and develops high-speed networking communications solutions for the Networking and Storage industry. See this link for more information. The Npwr single board computers are designed for manufacturers and OEMs in the Network Attached Storage (NAS), RAID, iSCSI and Personal Server marketplaces. They are powered by the Intel XScale 64 bit RISC processor with clock rates reaching as high as 733 MHz. The Npwr boards include a Intel XScale 80200 with 80312 Companion Chip (466, 600, and 733 MHz) 128-512 Megabytes SDRAM a 4 (32 opt.) Mbyte Flash ROM, Real Time Clock 19 Bit External Timer / Counter Dual Gbit Ethernet interface a high performance 320/160 Mbyte/s, PCI 64 bit wide SCSI interface. The Npwr form factor takes only a half height 5.25 slot on any external box or CPU case. The Npwr can be used as a stand-alone NetBSD or Linux server and an embedded RAID controller. Multiple units can be used to implement Linux clustered servers. Other Npwr applications include iSCSI controller, NAS Controller and Firewall/Router. The newest model, Npwr-FC, will be available at the end of 2002 and will allow to connect storage area networks with iSCSI via TCP/IP. It will include Intel XScale 80321 (up to 600 Mhz) Dual Fibre Channel ports four Serial ATA ports Dual Gigabit Ethernet ports 8-32 Mbytes of FLASH ROM 256-1024 Mbytes of DDR SDRAM NetBSD or Linux CDROM with tools, documentation and sources Npwr Server is a small self-enclosed Network Attached Storage (NAS) server that supports SMB, Appleshare IP, Appletalk and NFS. Specifications are similar to the Npwr SBC. It also includes a LVD SCSI hard disk (10, 30 or 60GB). If you know of any other companies that have products they support that run on any NetBSD port, please notify us so we can include them in this web page.